search Australian wreckers GetMeUsedCarParts.com used car parts search from Australian wreckers used car parts request




How to change the brake drums on a Honda Civic 2008


Posted by admin 1-03-2023

Brake drums are an essential component of a car's braking system, and they play a critical role in ensuring the safety of the driver and passengers. The Honda Civic 2008 model is a popular car, and changing the brake drums on this car is a relatively straightforward task that can be completed by most car owners with a few basic tools and some mechanical knowledge. In this article, we will guide you through the steps necessary to change the brake drums on a Honda Civic 2008 model.

Step 1: Gather the Required Tools

Before beginning the process of changing the brake drums on your Honda Civic, you will need to gather a few tools. These include a lug wrench, jack, jack stands, pliers, a hammer, and a flathead screwdriver. You should also have a replacement set of brake drums ready.

Step 2: Secure the Car

Park your Honda Civic on a flat surface, engage the parking brake, and put the car in gear. Use the lug wrench to loosen the lug nuts on the wheel where you plan to change the brake drums. Do not remove the lug nuts yet.

Step 3: Lift the Car

Place the jack under the car's frame, near the wheel you are working on, and jack the car up until the wheel is off the ground. Place jack stands under the car to ensure it remains safely elevated. Remove the lug nuts and take the wheel off the car.

Step 4: Remove the Brake Drum

Use the pliers to remove the retaining clips that hold the brake drum in place. These clips are typically located on the backside of the brake drum. Once the clips are removed, you should be able to slide the brake drum off the wheel hub.

Step 5: Install the New Brake Drum

Take your new brake drum and slide it onto the wheel hub. Ensure that it is aligned properly and seated correctly. If you have difficulty installing the new brake drum, use a hammer and gently tap the back of the drum until it slides into place. Replace the retaining clips that you removed in step 4.

Step 6: Reinstall the Wheel and Lower the Car

Place the wheel back on the car and thread the lug nuts back onto the wheel studs. Use the lug wrench to tighten the lug nuts as much as possible. Lower the car by removing the jack stands and lowering the jack.

Step 7: Test the Brakes

After you have changed the brake drums on your Honda Civic, it is important to test the brakes before driving the car. Pump the brake pedal a few times to ensure that the brake pads are seated correctly against the new brake drums. Then, take the car for a test drive around your neighborhood, paying close attention to the brakes' performance.

In conclusion, changing the brake drums on a Honda Civic 2008 model is a relatively straightforward process that can be completed by most car owners with basic mechanical knowledge and tools. By following the steps outlined above, you can replace the brake drums on your car and ensure that its braking system is functioning correctly, keeping you and your passengers safe on the road.

96319


GetMeUsedCarParts mentioned on 2GB 873AM in Nights with John Stanley - Car Advice with Trent Nikolic - 27th October 2021